Front: Ball Joint, reinforced

Fits in

• LADA Classic, all models, only in the upper wishbone arms
• LADA Niva's manufactured before 08.2010 in upper- and lower wishbone arms
• Fiat 124, all models, only in the upper wishbone arms

Contains the following parts

Fenox

• The protective coating of the ball bearing housing gives corrosion resistance and surface durability, which makes later dismantling of the ball joint easier.
• The pin of the ball joint is subjected to heat treatment and grinding, which guarantees high impact strength, low coefficient of friction and the longest possible life.
• Coating the threaded part of the ball pin with a zinc layer, gives high corrosion resistance and surface durability, which makes later dismantling of the ball joint easier.
• The protective boot is made from EPDM rubber with high resistance to: Frost, ozone and oil.
• The bushing of the ball has high antifriction- and shockproof properties, ensuring a smooth operation throughout the life of the product.

Made in Russia

• The wear resistance of the resin filling (the ball support) in the ball joint is raised by 10-15% compared to the traditional design
• The ball joint pin is cold forged (for increased stregth)
• The protective boot is made from EPDM rubber with high resistance to: Frost, ozone and oil.

Classic design as in the old days. It's possible to remove the boot (making it easy to clean and grease up). Has a screw that could be replaced with a grease nipple.

Made in Russia by Ptimas

No other information than: Reinforced !!