Prices are tax included
All parts that rotate: Propeller shafts, half shaft ...
and all the small parts: Seals, bellows, bearings ...
Half shaft for the rear axle beam. Fits in: LADA Niva 1700 without ABS, manufactured in the range around year 1998 - 2009. Length of half shaft = 78 cm
Half shaft for the rear axle beam. Fits in: LADA Niva 1600 manufactured before year 1998. Length of half shaft = 77 cm
Half shaft for the rear axle beam. Fits in: LADA Niva 1700 with ABS, manufactured after year 2009.
Complete bearing kit for left OR right side. Fits in: LADA Niva, manufactured before year 2002.
Support for the rear wheel bearing, with teeths for the ABS system. Fits in: LADA Niva 21214 with ABS.
Sealing ring for the rear axle beam and brake backplate. Fits in: All LADA Niva's
Rubber centering ring. Remember to install the small parts in the output shaft. They ensure vibrations will be kept at a minimum.
Original CV-joint for the lay-shaft or the new propeller shaft.
Original boot for the CV-joint. This is the standard boot mounted on all CV-joints in any LADA Niva.
Original protection cap for the rubber boot. This model is used on all standard rubber boots in any LADA Niva.
The little clip to hold the shaft in correct position inside the CV-joint. Sometimes that little clip just jumps out (and disappear Ꙭ) when disassembling the CV-joint from the shaft.
Original plug for CV-joint.